1. Determine mounting height of panels. For outside mounted panels, provide cover of 2-3 inches below window sill. For inside mounted panels, ensure hem is just on top of window frame. Mark height of panel on the surface by stretching full length of panel to the top.

2. Mount L- bracket to support the wooden rod holding the top panel. Screw in directly nail on holes of L bracket of wood surfaces. On concrete surface, a drill is required to put in tox case first, then crew in nail.

3. Screw in wood panel on L-brackets.

4. Attach fabric shade on Velcro tape on wood panel.

5. Insert cord on rod rings and knot on lower rings.

1. To move to desired length, pull cord inwards.
2. To lock, pull cord outwards.
3. To unlock and adjust shade length, pull cord inwards again.

1. Remove rods from back sheath/or inner folds. Tie rods together for easy retrieval.
2. Hand wash with mild soap and water without rubbing hard.
3. Rinse but do not squeeze to dry to avoid folds and lines.
4. Simply hang to dry. Iron if desired.

1.Insert rods on rod sheaths, tucking ends inside tube. Do the same for lower bar by
   pressing Velcro tapes at ends. For unsheathed rods, insert rods at the lining folds.
2.Attach fabric shade on Velcro tape on top wood panel.
3.Insert cord on cord rings and knot on lower rings.